Control Chief TM6000 Manual del operador Pagina 86
- Pagina / 201
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
TM 10-3930-660-10
0006 00-16
OPERATION UNDER UNUSUAL CONDITIONS - CONTINUED 0006 00
EMERGENCY BOOM OPERATIONS - CONTINUED
f. Connect the union end of the tow hose to the emergency steer pump hose that was disconnected in step e.
g. Disconnect both hoses from the base ends of the boom hoist cylinders at the main control valve tee fitting (bot-
tom left port). Install caps on the main controls valve tee fitting.
h. Connect the tee end of the tow hose to the boom hoist cylinder rod hoses that were disconnected in step g.
NOTE
If the boom will not raise during step i, move the hydraulic joystick lever to the boom raise position.
i. To raise the boom, make sure the emergency steer switch is on. Turn the start-run control switch on until the load or
forks are about 24 in. (61 cm) from the ground. Turn the starter-run control switch off.
j. After raising the boom, reconnect the lines by reversing steps b through h and return fitting to the emergency lift/
retract kit and the towing hose to the dummy tee.
k. Install transmission cover.
REAR WINDOW EMERGENCY EXIT
The rear window can be used as an emergency exit when exit through the cab doors cannot be made. To open the
emergency exit, proceed as follows:
1. While facing rear windows, grasp tag attached to rubber locking strip.
2. Pull tag and rubber locking strip fully out from rubber molding of rear window.
3. Push outward on rear window to remove rear window from cab.
4. Exit cab through rear window opening.
END OF WORK PACKAGE
409-3012
- TM 10-3930-660-10 1
- This page is blank 2
- AUTOMATIC FORK LEVEL 6
- BACK-UP ALARM 6
- COMPRESSED AIR 7
- DRY CLEANING SOLVENT 7
- ETHER COLD START SYSTEM 7
- FIRE EXTINGUISHER 8
- FUEL HANDLING 8
- HAZARDOUS WASTE DISPOSAL 8
- HEARING PROTECTION 8
- NBC EXPOSURE 9
- HYDRAULIC SYSTEM PRESSURE 9
- LOW BRAKE PRESSURE 9
- MAINTENANCE PROCEDURES 9
- PRESSURIZED COOLING SYSTEM 10
- SLAVE STARTING 10
- TRAVEL OF 6K FORKLIFT 11
- VEHICLE OPERATION 11
- Table of Contents - Continued 16
- HOW TO USE THIS MANUAL 17
- CHAPTER 1 19
- INTRODUCTORY INFORMATION WITH 19
- THEORY OF OPERATION 19
- 409-1722 29
- RADIATOR/ 31
- OIL COOLER 31
- 0003 00-7/(-8 Blank) 35
- HYDRAULIC SYSTEM - CONTINUED 35
- CHAPTER 2 37
- OPERATING INSTRUCTIONS 37
- 0004 00-8 46
- AUXILIARY FUEL 54
- SHUT-OFF SWITCH 54
- 409-028a 60
- 409-029a 60
- 0005 00-14 66
- ELECTRIC 69
- JOYSTICK 69
- SLAVE CABLE 71
- RECEPTACLE 71
- 409-3012 86
- 0007 00-2 88
- 0007 00-3/(-4 Blank) 89
- CHAPTER 3 91
- OPERATOR TROUBLESHOOTING 91
- CHAPTER 4 101
- 0011 00-4 106
- - ENGINE AND OIL CAN POINTS 107
- - TRANSMISSION 107
- - HYDRAULIC RESERVOIR 108
- - ANTIFREEZE 108
- 0011 00-7 109
- 0011 00-9 111
- 0011 00-10 112
- 0011 00-11 113
- LUBE POINT (GAA) 114
- LUBE POINT (OE/HDO) 114
- LUBE POINT 114
- HYDRAULIC OIL FILTER 115
- VIEW J - HYDRAULIC OIL FILTER 115
- 0011 00-14 116
- 0011 00-15 117
- 0011 00-16 118
- 0011 00-17 119
- 0011 00-18 120
- 0011 00-19 121
- (2 PLACES) (GAA) 123
- VIEW Z - CARRIAGE PIVOT PIN 123
- FRONT STEERING 126
- CYLINDER 126
- FRAME TILT STOP 126
- ENGINE AIR 127
- OVERFLOW 128
- ELECTRICAL 130
- HYDRAULIC 130
- 409-3006 131
- OIL FILL 136
- (OE/HDO) 136
- DIPSTICK 136
- 409-3008 137
- FUEL FILLER CAP 139
- 409-3010 140
- BATTERIES 142
- 409-3007 149
- OIL FILTER 152
- TRANSMISSION 154
- PISTON PUMP 154
- ADJUSTMENT KNOB 163
- BRAKE LEVER 163
- CHAPTER 5 167
- SUPPORTING INFORMATION 167
- LOAD BACKREST 173
- 0026 00-1/(-2 Blank) 183
- LOAD RATING CHART 0026 00 183
- LOAD RATING CHART 183
- END OF WORK PACKAGE 183
- INDEX - Continued 186
- 1 July 2006 191
- 1 May 2006 191
- PIN: 066858-000 200
- This fine document 201
Energizer AC13 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Narzędzia Energizer AC13.
Dostarczamy 1 pdf podręczników Energizer AC13 do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Comentarios a estos manuales