Control Chief TM6000 Manual del operador descargar pdf (Pagina 61)

TM 10-3930-660-10

0005 00-9

OPERATION UNDER USUAL CONDITIONS - CONTINUED 0005 00

STEER FORKLIFT - CONTINUED

4. Steering System Synchronization

. Use the following procedures to align the front and rear wheels if the wheels are not

set in the same direction after you change steering modes (4 wheel, 2 wheel, and crab steer).

a. Use steering wheel to put the rear wheels in a straight-ahead position.

b. Place steer select control switch in the 2 WHEEL position (center).

c. Use steering wheel and adjust the front wheels to a straight-ahead position.

d. Move steer select control switch to the desired mode for continued operation.

STOP FORKLIFT

1. Depress the brake pedal to slow vehicle down.

2. Bring the vehicle to a complete stop. Place travel select lever in Neutral “N” position.

3. Pull parking brake lever up to apply parking brake.

4. Move hydraulic joystick control lever left to retract the boom extend cylinder.

5. Push hydraulic joystick control lever forward to lower the boom until forks are resting on the ground.

STOP ENGINE

1. Place travel select lever in the Neutral “N” position.

2. Pull parking brake lever up to apply the parking brake.

3. Move hydraulic joystick control lever to retract the boom extend cylinder.

4. Push hydraulic joystick control lever forward to lower the boom until forks are resting on the ground.

409-024

BRAKE

TRAVEL

PARKING

PEDAL

SELECT

LEVER

BRAKE

LEVER

HYDRAULIC

STEERING WHEEL

JOYSTICK

STEER SELECT

SWITCH

STARTER-RUN

SWITCH

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 200 201

Sin comentarios

Control Chief TM6000 Manual del operador Pagina 61